Joined
·
28 Posts
Discussion Starter · #1 ·
Got these out to test.
They are really hard to find, and also hard to remove.
I had to remove the interior fuse box and bracket,
and then use a short stubby phillips screwdriver to remove the bracket holding the Main Relay and Fuel Pump Relay.
I have small hands and even then it was really hard to do.
I cant imagine someone with extra large hands doing this.
I will test the relays using the FSM procedure.
A quick summary of my problem, which I have posted in other threads.
After head gasket job, and also replacing the fuel filter.
I have a check engine light but no code.
Timing belt has been double and triple checked.
No start, but it cranks.
I have spark, fuel pump appears to work, it makes sounds, and whirrs.
Fuel comes of the OUT line of the fuel filter when the gas pedal is pressed.
Car will start with starter fluid in intake, but dies as the Fuel shuts off.
I suspect computer is shutting off the fuel.
I connected the 2 green test connectors and I can hear the fuel pump whirr,
and also return fuel splash to the tank.
Looking at the main relay and fuel pump relay now.
Joined
·
28 Posts
Discussion Starter · #2 · (Edited)
I tested according to FSM, and all the main relay does is buzz.
There is no resistance across terminal 3 and 5 or 4 and 6.
Does this mean the relay is bad ?
I applied 12volt through an AC adaptor, as didnt have battery on hand.
It was really putting out 14 volts though, so not sure if that is too high for the relay.
Posting the FSM pages below.
Anybody done this test before ?
Update: The AC adapter I used had a very low Amperage. It's probably not a valid test.
Joined
·
28 Posts
Discussion Starter · #3 ·
Ok, I applied 12 volts from car battery to the Main Relay and the Fuel Pump relay.
They both read about .4 Ohms, which is fine.
Both of these are working, and dont need to be replaced.
I also verified that Fuel pressure is about 40PSI.
Fuel pump is working.
Joined
·
1 Posts
Hi Silentguy,
What was the final solution? I am experiencing symptoms almost identical to yours and am having a hell of a time getting the main relay out. Wanted to know if there was something else I should be looking at before cutting my hand up any more trying to get that thing out.
1997 Legacy GT
Replaced head gasket (pulled engine)
Plug battery in, security lights flash, go off when I use keyfob
Car turns over, but doesn't start
After trying to start, the dash lights are in 'brownout' mode - kind of flickering. Also, I can turn on the AC fans with the key out (stuck relay somewhere?)
Tests done:
Checked all fuses and relays (except main and fuel relay)
Plugged in fuel pump with 12V battery and it runs, tried starting like that and no difference. Fuel squirted out of line when plugged in, but not when trying to start normally
Double or triple checked all grounds and connections in engine bay. DMM says good ground connection to block, trans, frame.
Thoughts?
Joined
·
203 Posts
try checking the park neutral safety switch on the side of the transimssion if you have an automatic
2002 Forester L series Automatic
Joined
·
10 Posts
Was the fix ever found that you could post?
Joined
·
17 Posts
I know this is an old post cos I looked at it when trying to sort out a similar issue and a solution probably would have saved me about $600. Fuel pump ok. Spark fine but no injector pulse. Not sure if this was Silentguys issue but my problem was a faulty transponder in the key. I hope this info helps anyone else searching old posts for solutions and saves you some money.
Source: https://www.subaruforester.org/threads/1998-main-relay-and-fuel-pump-relay.120221/
Posted by: imogenedisse1952aeo.blogspot.com
Posting Komentar